 |
Front Lower Left Plastic Trim Not broken, but has scratches. Reduced 50%. Normally $45.00

|
 |
 |
Rear Lower Left Molding
|
 |
 |
Rear Upper Left Molding
|
 |
 |
Front Lower Right Plastic Trim
|
 |
 |
Rear Lower Right Molding
|
 |
 |
Rear Upper Right Molding
|
 |
 |
Rear Lower Molding
|
 |
 |
Rear Upper Molding
|
 |
 |
Dash Cover - Front Front molding fits just forward of the instrument cluster panel.

|
 |
 |
Dash Cover - Rear This is the plastic mold around the instrument cluster with holes for switches and instrument panel.

|
 |
 |
Battery Bay Cover 
|
 |
 |
Seat Bucket Seat bucket does not include the battery compartment shown below.

|
 |
 |
Battery Compartment
|
 |
 |
Tail Section ( Inner Fender) Black plastic tail fender for Tank 150/Bali 150. Does not include lic. plate bracket or reflectors.

|
 |
 |
Carburetor Cover
|
 |
 |
Floor Board - Left
|
 |
 |
Floor Board - Right
|
 |
 |
Gas Cap Cover
|
 |
 |
Lower Engine Cover
|
 |
 |
Seat Bucket Front Molding
|
 |
 |
Steering Column Molding Inside console molding with speaker holes.

|
 |
 |
Steering Console Molding Connector Plate This plate goes under the instrument panel and completes the steering column molding assembly, making the molding secure around the steering column.

|
 |
 |
Underbody Fender
|
 |
 |
|
 |
 |
Red rectangular reflector Rectangluar reflector for tail section.

|
 |
 |
Rear Fender( mud guard) Rear fender body that attaches directly behind the engine and guards the back of the scooter from mud and road debris.
**** May not fit some 2006 and newer models - please check photograph and make sure your fender matches the one in our photo! ***

|
 |
 |
Body Panel Screw Set, Pack of 10 10-pack of the small screws that attach the body panels( fairings) to the scooter.

|
 |
 |
Body Panel Clips These OEM panel clips are sold in packs of 10 clips. Used to add strength to the panel's mounting tabs when they are screwed into place, they are essential to making sure you minimize stress on the panel tabs. Each pack of 10 clips is $4.95.

|
 |
 |
Complete Set, Tank Touring 150 Hardware Almost every nut, bolt and screw on a Tank Touring 150 model. Body panel screws, bolts, fastners, etc. ( Does not include axle bolts and axle nuts, axle spacers, exhaust bolts and acorn nuts and a few other large bolts, etc.)

|
 |
 |
Front Cowling - Plastic 
|
 |
 |
Front Fender
|
 |
 |
Front Handle Bar - Plastic Trim Picture is for silver color, but only color available is champagne. Only one piece left.

|
 |